Thingiverse
Zortrax M200 Filament Aligner
by JesusRT
12
Downloads
5
Likes
1
Makes
Hi there!
I've designed the aligner, after having problems with filament's feeding into the extruder.
At first I thought I was having clogs... then I thought it could be an issue with the temperature control (I got the covers "just in case")... swapping spools... etc.
After trying everything, including replacing the entire hot-end, nothing seemed to work.
So I went piece by piece, examining what could be causing this. And I found out that the hole that holds the filament tube, is in a "b
I've designed the aligner, after having problems with filament's feeding into the extruder.
At first I thought I was having clogs... then I thought it could be an issue with the temperature control (I got the covers "just in case")... swapping spools... etc.
After trying everything, including replacing the entire hot-end, nothing seemed to work.
So I went piece by piece, examining what could be causing this. And I found out that the hole that holds the filament tube, is in a "b
Sign in to leave a comment
Sign in