Thingiverse
Duplicator i3 Hotend / Print Area LED Holder
by Airmaxx23
218
Downloads
117
Likes
0
Makes
***Please note that this will require using an M4 x .7 tap to thread the 2 bottom existing holes on the lower X axis bearing carrier and you will need 2 - M4 x 6 or 8 button/cap head screws***
This is a holder for an automotive 12v dome light LED bulb to light up the print area / bed so that you can see the extruder / hotend. I simply removed the cover on the ends of the LEDs, soldered wires to the rear of the LEDs and crimped on some ends. I made a small Y-harness to draw power from where
This is a holder for an automotive 12v dome light LED bulb to light up the print area / bed so that you can see the extruder / hotend. I simply removed the cover on the ends of the LEDs, soldered wires to the rear of the LEDs and crimped on some ends. I made a small Y-harness to draw power from where
Sign in to leave a comment
Sign in