Thingiverse
Prusa Original Middle Dual Spool Holder
by Codeplayer
5
Downloads
9
Likes
1
Makes
This is a middle spool holder For Prusa Original 1.75mm.
- Meant for mounting two spools of filament, using the two holders that are already included with the Prusa Original printer (kit)
- The cylinder and hole edges are rounded for easy fit.
- No supports needed for the rounded edges.
- Print with 0,2mm layer height to achieve similar seamless result as your Prusa.
- Prints in 2 hours and 8 minutes (PLA) on your Prusa Original with 0,2mm layer height.
The Prusa Original parts are d
- Meant for mounting two spools of filament, using the two holders that are already included with the Prusa Original printer (kit)
- The cylinder and hole edges are rounded for easy fit.
- No supports needed for the rounded edges.
- Print with 0,2mm layer height to achieve similar seamless result as your Prusa.
- Prints in 2 hours and 8 minutes (PLA) on your Prusa Original with 0,2mm layer height.
The Prusa Original parts are d
Sign in to leave a comment
Sign in