Thingiverse
E3D Titan Extruder & V6 Hotend Carriage for Leapfrog Creatr (WIP)
by redrum69
80
Downloads
63
Likes
0
Makes
This is a replacement carriage that accepts a single E3D Titan extruder, and v6 hotend!
A WORK IN PROGRESS!
Print the carriage on its side. A couple of supports are needed on the inside. The bracket also works as a 2mm spacer which is usually needed on Titan. You'll need 4 screws to mount the rear bracket. I cant remember the size off the top of my head. You may also need some different length M3 screws for the Titan on the bottom.
Fitting the v6 fan underneath is a little tricky. It
A WORK IN PROGRESS!
Print the carriage on its side. A couple of supports are needed on the inside. The bracket also works as a 2mm spacer which is usually needed on Titan. You'll need 4 screws to mount the rear bracket. I cant remember the size off the top of my head. You may also need some different length M3 screws for the Titan on the bottom.
Fitting the v6 fan underneath is a little tricky. It
Sign in to leave a comment
Sign in