Printrbot LC V2 Conversion : Metal Gear Extruder + Bowden + E3D Hotend

This is a conversion kit for the following parts :

- E3D Hotend : http://e3d-online.com/ourshop/prod_2781400-E3Dv5-All-metal-HotEnd-175mm-Direct-Extrusion.html
- Metal Gear System Extruder : http://www.reprapsource.com/en/shop/list/201
- Bowden cable

It **should** work with the bowden provided with the E3D hotend, just check the pneufit thread diameter.

Be careful with your printer calibration, especially for the carriage : any misalignment will "block" the carriage on the rods.