Thingiverse
E3D v6 Prusa i3 Mount with 2x 40mm fan ducts
by David_L_G
59
Downloads
41
Likes
0
Makes
This is a remix of the excellent Thing N°547706 by Tech2C :
http://www.thingiverse.com/thing:547706
PLEASE TAKE NOTE :
There is a right and a left fan duct.
There are two versions of the carriage, one is for the prusa i3 Hephestos and the other is a more generic one, choose wisely.
/!\ This design will blow A LOT of air on your print, while this is great for bridging and overhangs, setting the fans to 100% might cause your prints to delaminate, if so, lower the fan speed.
Bill of
http://www.thingiverse.com/thing:547706
PLEASE TAKE NOTE :
There is a right and a left fan duct.
There are two versions of the carriage, one is for the prusa i3 Hephestos and the other is a more generic one, choose wisely.
/!\ This design will blow A LOT of air on your print, while this is great for bridging and overhangs, setting the fans to 100% might cause your prints to delaminate, if so, lower the fan speed.
Bill of
Sign in to leave a comment
Sign in