Thingiverse
Printrite DIY - Ramps 1.4 mount case
by shawdreamer
100
Downloads
67
Likes
0
Makes
Just finished swapping out my Colido/Printrite DIY 3d printer's Mainboard for a full Ramps 1.4 setup.
these designs are to allow the Ramps board to be housed in the same location as the original Printrite board and to house the connected full graphics lcd controller in a self contained case that can be left as "standalone" as I have, or screwed/bolted somewhere you might find convenient.
the ramps backplate use the two left most original screws and the upper centre clip point (using a zip
these designs are to allow the Ramps board to be housed in the same location as the original Printrite board and to house the connected full graphics lcd controller in a self contained case that can be left as "standalone" as I have, or screwed/bolted somewhere you might find convenient.
the ramps backplate use the two left most original screws and the upper centre clip point (using a zip
Sign in to leave a comment
Sign in