3D Print of Orkaz Walls

The full Orkaz Walls set printed in resin! This was printed on an Anycubic Photon P1 using Sunlu Water-Washable ABS-Like resin. The print went without a hitch with zero failures. The ladders shown are from the StationForge Orkaz Slums set. Putting this together was a bit of a tricky puzzle, even with the instructions (which uses different part identifiers than the actual filenames). I also decided to drill-and-pin many of the parts as I glued them together since there is not a lot of "keying" included with these parts. The "building" makes four nice quarters that you fit together or split apart, and platforms to span the gaps. This is such a cool and versatile set that should look amazing once painted.