Thingiverse
DIY PrintRite X-axis Adjustable Belt Connector
by 1sPiRe
39
Downloads
40
Likes
1
Makes
Remixed from the work of Walter.
The shim is 10mm height, scale it on Z axis to adjust the height you need. However 10mm shim should be close to the height you'll need if you keep the teflon (or whatever it is) spacers.
Teeth parts should be printed at 0.1 layer height.
You will also need to replace screws by longer ones...at least M3*45mm
The shim is 10mm height, scale it on Z axis to adjust the height you need. However 10mm shim should be close to the height you'll need if you keep the teflon (or whatever it is) spacers.
Teeth parts should be printed at 0.1 layer height.
You will also need to replace screws by longer ones...at least M3*45mm
Sign in to leave a comment
Sign in