FuseBox 1515 hot end blower nozzle

**NOTE: THIS MODEL HAS SOME QUALITY ISSUES THAT I AM ADDRESSING IN A FUTURE UPDATE**
**The front edge of my prints were popping off prematurely and I suspected it was due to the fan excessively cooling the bed. Ran a SolidWorks flow sim on the part and there it was! http://prntscr.com/b9ldv1 -- I am redesigning the fan to focus air on the top layer of the print and slightly below, assuming you turn on the fan around layer 5 or so which should correspond to about 0.5-1.5mm.**

This model will