Thingiverse
Fan duct for 3KU Delta printer
by tothistvan87
19
Downloads
24
Likes
2
Makes
The fan on my 3KU Delta printer was not aligned to cool around the hotend, so I made this fan duct to correct this.
**EDIT**:
v1.1 sits about 0.5 mm higher, and is a little bit shorter so it should not bump into the prints, especially when printing things
**EDIT**:
v1.1 sits about 0.5 mm higher, and is a little bit shorter so it should not bump into the prints, especially when printing things
Sign in to leave a comment
Sign in