Thingiverse
BQ Prusa i3 Hephestos Autolevel (no servo needed)
by ret1
16
Downloads
10
Likes
0
Makes
what is it good for
its a new autolevel mechanism i made for my BQ Prusa i3 Hephestos but it should fit on other printers too. unless other autolevel solutions, no probing servo is needed. also there is no probe offset for x and y and very little for z and you only need to print one part, if you reuse some parts of your printer.
how it works
in normal operation, the 2 wires of the z endstop touch the upper linear ball bearing, doing a shortcut. if the extruder tip is hitting the glass base
its a new autolevel mechanism i made for my BQ Prusa i3 Hephestos but it should fit on other printers too. unless other autolevel solutions, no probing servo is needed. also there is no probe offset for x and y and very little for z and you only need to print one part, if you reuse some parts of your printer.
how it works
in normal operation, the 2 wires of the z endstop touch the upper linear ball bearing, doing a shortcut. if the extruder tip is hitting the glass base
Sign in to leave a comment
Sign in