Thingiverse
It Doesn't Have to Look Like Raspberry Pi Zero Case #2
by DaHai8
28
Downloads
29
Likes
1
Makes
YAIDHTLLARP0C (Yet Another 'It Doens't Have to Look Like a Raspberry Pi Zero Case)
This one is bigger and takes longer to print - over three hours.
The Pi slides in from underneath and sits flush with the table - also held into place by the power plug in the back (power, usb, micro HDMI in back).
There is an air vent in the top-back. Plus two air holes in the base that also help if your Pi Zero gets stuck. Just use needle-nose pliers a those points to gently pull it out.
I think it
This one is bigger and takes longer to print - over three hours.
The Pi slides in from underneath and sits flush with the table - also held into place by the power plug in the back (power, usb, micro HDMI in back).
There is an air vent in the top-back. Plus two air holes in the base that also help if your Pi Zero gets stuck. Just use needle-nose pliers a those points to gently pull it out.
I think it
Sign in to leave a comment
Sign in