Wiper for Flashforge Creator Pro

This part wipes the filament off the extruder before the print begins. It's a simple design that is made for a brush, but also works very well if a staple or wire which will complete the same task.

The G-code needed to run it is a simple five lines of code. You need to copy and paste the lines below before the printer prints a test line. If you use Slic3r, you can just add it to the 'start G-code'.

G1 X146 Y-20 Z11 F9000
G1 X146 Y20 Z11 F9000
G1 X146 Y-20 Z11 F9000
G1 X146 Y20 Z11 F9000