Thingiverse
One punch man, Saitama's belt buckle
by charcham7
179
Downloads
184
Likes
1
Makes
I scaled it to 108mm on the Y axis when I printed it. Turned out super good!
I printed it out bottom to top, so I had to use a lot of support structures. I even used a raft because there was so much support structure that needed to adhere. After its done, all that support is on the back side though, so I feel like it's worthwhile.
I printed it out bottom to top, so I had to use a lot of support structures. I even used a raft because there was so much support structure that needed to adhere. After its done, all that support is on the back side though, so I feel like it's worthwhile.
Sign in to leave a comment
Sign in