Thingiverse
Watering Can Spout
by YardCamel
38
Downloads
27
Likes
0
Makes
My wife was complaining that her watering can spout- the part with the holes in it that makes the water "sprinkle" had a hole rusted in it, making it not "sprinkle" worth a darn.
Out come the calipers and FreeCAD, and a few hours later: voila! New sprinkler doodad for the watering can.
I made this one on my PrintrBot Simple Metal using a 100% fill density with 4 shells (for strength). Print bed at 80c and SmartBuy gray ABS extruded at 250c. A little AquaNet Super Hold hair spray on the
Out come the calipers and FreeCAD, and a few hours later: voila! New sprinkler doodad for the watering can.
I made this one on my PrintrBot Simple Metal using a 100% fill density with 4 shells (for strength). Print bed at 80c and SmartBuy gray ABS extruded at 250c. A little AquaNet Super Hold hair spray on the
Sign in to leave a comment
Sign in