Thingiverse
Y-Axis Direct Drive for CTC Replicator Flashforge
by 3DWorkhorse
138
Downloads
83
Likes
1
Makes
> Recommended for heated build chambers! (to protect stepper from the heat)
Hi folks!
Another upgrade item for your replicator-like 3D printer. It is a mount to drive the y-axis' rod directly without another belt, so there is no additional force on the y-rod (no bending, easier to rotate) and no backlash due to a "loose" belt.
I found that my prints are a bit more precise since the upgrade. Especially the ringing effect (wave pattern after sharp corners) was reduced on the y-axis.
> Wh
Hi folks!
Another upgrade item for your replicator-like 3D printer. It is a mount to drive the y-axis' rod directly without another belt, so there is no additional force on the y-rod (no bending, easier to rotate) and no backlash due to a "loose" belt.
I found that my prints are a bit more precise since the upgrade. Especially the ringing effect (wave pattern after sharp corners) was reduced on the y-axis.
> Wh
Sign in to leave a comment
Sign in