15X15 OpenBeam reversible hinge

This a reversible hinge designed to be used as part of a post-curing cabinet for SLA UV active resin. The hinge prints in place as one piece but is held together with detents so in order to use it you need to separate the two parts then put it back in the other way so it sits flush to the OpenBeam. The hinge was initially meant for gluing to a 3mm sheet of Lexan (hence the notch) but you could glue it to just about anything. This part was designed for use with M3 screws. It was printed on a Cell Robox at 20% infill with a nozzle temp of 235C, Bed temp of 115C, an ambient of 60C, and a flow rate of 0.95. Enjoy!