Thingiverse
piip66
by Nemiah
12
Downloads
6
Likes
0
Makes
Parts for fitting a Raspberry Pi 3 with Adafruit LCD in a water protected IP66 enclosure.
The left side of the inner enclosure can be lifted off by squeezing your fingers after putting them in the top and bottom holes. The part holds in place without screws.
The right side is mounted with three screws on the scaffolding.
All Raspberry Pi ports are accessible. You'll need an angled connector for the power though. It is quite tight in there.
An extra handle keeps the Pi in place.
Th
The left side of the inner enclosure can be lifted off by squeezing your fingers after putting them in the top and bottom holes. The part holds in place without screws.
The right side is mounted with three screws on the scaffolding.
All Raspberry Pi ports are accessible. You'll need an angled connector for the power though. It is quite tight in there.
An extra handle keeps the Pi in place.
Th
Sign in to leave a comment
Sign in