Thingiverse
Small sliding bolt
by Sagittario
237
Downloads
208
Likes
1
Makes
This is a small sliding cupboard/door bolt.
I have added slots in the main body to allow the bolt to be locked into the opened and closed positions.
Assembly should be simple. just a little but not too much superglue on the pin when assembling the main body.
If the small pin is not printing properly, try laying it flat or maybe on a raft.
As for print settings, 50-80% infill at least 2 shells (perimeters)
If the body or receiver is too tight, try cleaning up with an 8mm drill run ba
I have added slots in the main body to allow the bolt to be locked into the opened and closed positions.
Assembly should be simple. just a little but not too much superglue on the pin when assembling the main body.
If the small pin is not printing properly, try laying it flat or maybe on a raft.
As for print settings, 50-80% infill at least 2 shells (perimeters)
If the body or receiver is too tight, try cleaning up with an 8mm drill run ba
Sign in to leave a comment
Sign in