Thingiverse
(The Linear) lightsaber
by Aos4life
49
Downloads
34
Likes
0
Makes
This lightsaber is 'The Linear', named by Frank Roop III.
I have provided a full saber model as well as a 3 part sliced version.
It is designed to allow a 1 inch OD PVC pipe or similar as the blade, using an M4 screw (or any type of pin that is 0.15 inches) as a blade holding pin. as long as my measurements are correct that is.
I have test printed it and it turned out better than expected. it should print flawlessly as long as you use supports for the pommel and grip.
I do this in my s
I have provided a full saber model as well as a 3 part sliced version.
It is designed to allow a 1 inch OD PVC pipe or similar as the blade, using an M4 screw (or any type of pin that is 0.15 inches) as a blade holding pin. as long as my measurements are correct that is.
I have test printed it and it turned out better than expected. it should print flawlessly as long as you use supports for the pommel and grip.
I do this in my s
Sign in to leave a comment
Sign in