Traxxas Ball Joint Arm Assembly Jig

FYI for some reason when exported as .STL, Autodesk twisted the part around so use Thingiview to get a good look at the actual STL. Anyway.

This is a rod ball jig for Traxxas 5347 ball joints and 10mm OD CF tube.

YOU NEED TO PRINT TWO OF THESE TO BUILD DELTA ARMS.

You can use this for any length delta arms as long as it uses 5347 ball joints and 10mm CF tubing. Just square them up so the post centers are your delta_arm_length, make absolutely sure they're square, and then the rest goes