Xiaomi yi gimbal enclosure - no screw type

The cam is strongly secured, but easily removed if needed, without any screw or annoying system.

You will need:
1x 6mm long M2 screw
1x M2 nut
4x M2 inserts (2.5mm, but I think you can force 3mm inserts, heating them well)


Printable without support.
I suggest 25% infill honeycomb in ABS, it will weight about 12g.
3 perimeters are good.
the shaft is 3mm (but you can drill it up to 5)

------------------------------------

UPDATED

main case vers2
I shifted a bit the mounting