Thingiverse
Adafruit Trinket wire organizer and holder
21
Downloads
14
Likes
0
Makes
This is the first part of a series of things I made for an upcoming music festival.
I wanted to make sure I had backup Trinkets in case something went wrong. So I created a little "card" and a holder I will post later that attaches to a PVC tube.
With 3 of these wired up and ready to go I can quickly detach the clips and pull the card out and slide a new one in and keep it all going. Or I could write different programs on all the cards and swap them as needed.
I wanted to make sure I had backup Trinkets in case something went wrong. So I created a little "card" and a holder I will post later that attaches to a PVC tube.
With 3 of these wired up and ready to go I can quickly detach the clips and pull the card out and slide a new one in and keep it all going. Or I could write different programs on all the cards and swap them as needed.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in