Thingiverse
mpCNC upgraded tool mount for dremel
by amats
34
Downloads
22
Likes
0
Makes
Not many to say... a quick dirty fix to apply the already designed dremel mount for the new toolplate on mpcnc.
Not printed yet... actually printing it right now.. so it not tested yet!!!
UPDATE!!! Yeap it turned out perfect (for my needs at least). I think the holes on the upper front piece to ease screwing the upper back piece needed a little better angle calibration but it was piece of cake to put it on the new toolmount of mpcnc.
As i followed the prototype's diameter i had to put
Not printed yet... actually printing it right now.. so it not tested yet!!!
UPDATE!!! Yeap it turned out perfect (for my needs at least). I think the holes on the upper front piece to ease screwing the upper back piece needed a little better angle calibration but it was piece of cake to put it on the new toolmount of mpcnc.
As i followed the prototype's diameter i had to put
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in