Thingiverse
Light Saber v.3
by ticticboom
34
Downloads
15
Likes
0
Makes
This is a totally original design made out of base polygons from scratch which I was inspired to make while watching star wars at 4 am.
To Print:
First, use the version of the light saber that is halved as it prints better. At the end when you get them off you can glue them together (most glues will do) and secure them with rubber bands to hold them together until the glue dries then enjoy your light saber.
To Print:
First, use the version of the light saber that is halved as it prints better. At the end when you get them off you can glue them together (most glues will do) and secure them with rubber bands to hold them together until the glue dries then enjoy your light saber.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in