Thingiverse
Kossel Effector for Generic Chinese All Metal Hotend
36
Downloads
24
Likes
1
Makes
**This design is now obsolete. Please see the following page for an updated version
Here**
These files were created from heavily butchered SCAD files made by jcrocholl on the Kossel Github. I needed a new effector for my brand new Sintron 3D printer as minimal effort had been made to see if the rod ends would fit the original effector design.
The thread holes for the rod mounts are 2.9mm and are designed to accept 3mm or 3/32" coarse thread screws, common at most hardware stores. I prefe
Here**
These files were created from heavily butchered SCAD files made by jcrocholl on the Kossel Github. I needed a new effector for my brand new Sintron 3D printer as minimal effort had been made to see if the rod ends would fit the original effector design.
The thread holes for the rod mounts are 2.9mm and are designed to accept 3mm or 3/32" coarse thread screws, common at most hardware stores. I prefe
Sign in to leave a comment
Sign in