E3D V6 Wades Extruder - BL Touch Mount

Designed this to replace the side locking piece from my favorite Extruder on the Folgertech Prusa i3 2020.

Install the BLTouch on the outer piece and slide the wires up the groove, put the inner piece on your screws and assemble as normal to lock the E3D in place.

You'll need to measure your offset on Z depending on your hotend and nozzle setup but in Marlin 1.1.0 RC3 (line 492) mine is:

// Offsets to the Z probe relative to the nozzle tip.
// X and Y offsets must be integers.
X_