Thingiverse
Di3 v2.1 Spacer for Thorped's Fan Duct
by charlesdill
305
Downloads
120
Likes
2
Makes
This spacer will adapt [Thorped's WANHAO Fan duct](http://www.thingiverse.com/thing:1246425) to a Di3 v2.1 bearing block.
One edge is a bit thinner for a better fit under the belt because I have this [belt clamp](http://www.thingiverse.com/thing:1620700) installed.
Installed using two M4 x 35mm button head screws with washers under the heads, inserted from the front of the printer, with spring washers and nuts on the back. I had to grind the screws down to ~32mm and use regular nuts with s
One edge is a bit thinner for a better fit under the belt because I have this [belt clamp](http://www.thingiverse.com/thing:1620700) installed.
Installed using two M4 x 35mm button head screws with washers under the heads, inserted from the front of the printer, with spring washers and nuts on the back. I had to grind the screws down to ~32mm and use regular nuts with s
Sign in to leave a comment
Sign in