Thingiverse
Dual Fan Duct for Rostock Printer
by Morbias86
2
Downloads
4
Likes
0
Makes
These are two individual fan ducts for 40x40mm fans for the Rostock printer (http://www.thingiverse.com/thing:17175), one for the thermal barrier and one for cooling the print.
Needed for assembly:
40x40mm fans (2x)
M3x16mm Screws (11x)
M3 Nuts (9x)
M3 Washers (3x)
The reason I designed this is:
I used to print with a single fan attached to the delta printer plattform which was always on and blew a constant stream of air over the print bed. Unfortunately the airstream also lifted up t
Needed for assembly:
40x40mm fans (2x)
M3x16mm Screws (11x)
M3 Nuts (9x)
M3 Washers (3x)
The reason I designed this is:
I used to print with a single fan attached to the delta printer plattform which was always on and blew a constant stream of air over the print bed. Unfortunately the airstream also lifted up t
Sign in to leave a comment
Sign in