Thingiverse
Power PCB Support RoboCat 270mm / Quadcopter Drone
by _sOnGoKu_
14
Downloads
11
Likes
0
Makes
This support allows you to install the PBC Power on the chassis of the 270 RobocaT.
Fits perfectly to the holes wide carbon fiber chassis.
The 3d printable piece more small, used to secure the PBC once installed.
Dont forget this Power Board is designed for octocopetrs, so you have to cut it so it fits into the Robocat 270 Frame. Otherwise not be possible install the side frames of the skeleton.
The resoult is perfect and secure.
if you want a little more information about the Robo
Fits perfectly to the holes wide carbon fiber chassis.
The 3d printable piece more small, used to secure the PBC once installed.
Dont forget this Power Board is designed for octocopetrs, so you have to cut it so it fits into the Robocat 270 Frame. Otherwise not be possible install the side frames of the skeleton.
The resoult is perfect and secure.
if you want a little more information about the Robo
Sign in to leave a comment
Sign in