Thingiverse
Navio2 Autopilot case
by mcancino
25
Downloads
22
Likes
0
Makes
After some time the case for Navio2 is ready!!
Print both parts with the flat surface pointing to the bottom, using support material in the slot where the power, I2C, etc connectors go.
Use 2 bottom and top layer. 2 perimeters and 20% infill.
Use M2.5x8 Allen screws (recomended) to put everything together.
UPDATE: Slot for RPi3 SD card easy removal. Retrofitting upper cap for PWM pins and base for available Damper platform (https://docs.emlid.com/navio2/Navio-APM/hardware-setup/)
Print both parts with the flat surface pointing to the bottom, using support material in the slot where the power, I2C, etc connectors go.
Use 2 bottom and top layer. 2 perimeters and 20% infill.
Use M2.5x8 Allen screws (recomended) to put everything together.
UPDATE: Slot for RPi3 SD card easy removal. Retrofitting upper cap for PWM pins and base for available Damper platform (https://docs.emlid.com/navio2/Navio-APM/hardware-setup/)
Sign in to leave a comment
Sign in