Thingiverse
Hakko T12 AT/ATX version front (STM32 and simple version)
by ZhenyaKa
30
Downloads
20
Likes
0
Makes
Power source connected between -12V and +12V. We have 24V for fast heating.
3 diodes was replaced in -12V line. Them was for 1A current only. Replace on 5A diodes.
Added red led-diode between -12V and 12V with 10k resistor. STM version starts with some delay.
What all AT modification :)
ATX mod need to use "power on" signal (green wire connect with ground - black wire)
Very cheap and good solution with many options and mega fast heating (about 7 seconds).
PCB was bought on taobao
3 diodes was replaced in -12V line. Them was for 1A current only. Replace on 5A diodes.
Added red led-diode between -12V and 12V with 10k resistor. STM version starts with some delay.
What all AT modification :)
ATX mod need to use "power on" signal (green wire connect with ground - black wire)
Very cheap and good solution with many options and mega fast heating (about 7 seconds).
PCB was bought on taobao
Sign in to leave a comment
Sign in