Thingiverse
Printrbot Play USB holder
by fukanchik
38
Downloads
22
Likes
1
Makes
Printrbot Play USB connector holder.
WARNING: Uploaded STL fits into my particular printer and USB cable. Yours might require size customization!
WARNING: Make sure cable enters the socket easliy when holder is in place! Otherwise you would eventually break your socket. Adjusting PEG vertical size will allow to customize this.
Motivation:
Printrbot Play USB socket is designed to break and fall out. It is hanging below the board on four tiny legs holding the weight and wobbling of the c
WARNING: Uploaded STL fits into my particular printer and USB cable. Yours might require size customization!
WARNING: Make sure cable enters the socket easliy when holder is in place! Otherwise you would eventually break your socket. Adjusting PEG vertical size will allow to customize this.
Motivation:
Printrbot Play USB socket is designed to break and fall out. It is hanging below the board on four tiny legs holding the weight and wobbling of the c
Sign in to leave a comment
Sign in