Thingiverse
DaVinci E3D v6 dobuble fan carriage.
by firecardenal
95
Downloads
68
Likes
0
Makes
Da Vinci E3D v6 Carriage.
In this version, I use dual 30mm fans.
The lateral fan is for cool down the printed area through an inner tunnel.
The rear/front fan is for cool down the E3D hot sink.
The slot for the belt, now has 3 holes for inserting oppressors and tighten the belt in place.
I use a 30mm.5 volt fan for the hot sink.because is the voltage on the actual 40mm fan. and I use a 12volt fan for the printed area because I added a 12volts line direct from the electronic board.
In this version, I use dual 30mm fans.
The lateral fan is for cool down the printed area through an inner tunnel.
The rear/front fan is for cool down the E3D hot sink.
The slot for the belt, now has 3 holes for inserting oppressors and tighten the belt in place.
I use a 30mm.5 volt fan for the hot sink.because is the voltage on the actual 40mm fan. and I use a 12volt fan for the printed area because I added a 12volts line direct from the electronic board.
Sign in to leave a comment
Sign in