Thingiverse
Spring Drive Block Extruder for CTC Bizer (Replicator Clone) MK8 Remix for Makerbot Clone 3D Printers (FlashForge, Wanhao)
by jerryjs8
119
Downloads
68
Likes
2
Makes
Thing Status: Proven/Stable
I've been using this drive block for some time now, and have installed it on a few other CTC's without any problems. But then again, it was a tried and proven base model before I started messing with it...
I did however have a couple of quarrels with the MK8 Spring Block and edge of the heatbreak shaving off filament on my CTC because it wasn't properly aligned . This lead to my prints being sprinkled with filament shavings and a loaded drive gear after a few hou
I've been using this drive block for some time now, and have installed it on a few other CTC's without any problems. But then again, it was a tried and proven base model before I started messing with it...
I did however have a couple of quarrels with the MK8 Spring Block and edge of the heatbreak shaving off filament on my CTC because it wasn't properly aligned . This lead to my prints being sprinkled with filament shavings and a loaded drive gear after a few hou
Sign in to leave a comment
Sign in