Thingiverse
RPi tray with captive M3 nuts
by Alzibiff
31
Downloads
17
Likes
0
Makes
The changes to the original are as follows:
1. Added cut outs for a pair of M3 nuts underneath so that the Pi can be attached though the original holes using M3 x 8mm screws
2. Increased the width of one of the struts carrying one of the mounting holes. (Photos show an earlier incarnation - the attached STL is has the wider strut).
I made these changes in order to attach a RPi to my Mendel90 dibond kit from Nophead. The Pi Tray was fixed using double sided tape to the top of the PSU and
1. Added cut outs for a pair of M3 nuts underneath so that the Pi can be attached though the original holes using M3 x 8mm screws
2. Increased the width of one of the struts carrying one of the mounting holes. (Photos show an earlier incarnation - the attached STL is has the wider strut).
I made these changes in order to attach a RPi to my Mendel90 dibond kit from Nophead. The Pi Tray was fixed using double sided tape to the top of the PSU and
Sign in to leave a comment
Sign in