16amp cable entry assembly

These were designed using Fusion 360 software from AUTODESK.

I required a rainproof method of supplying my garden shed with mains power and needed to allow for the flange nut entry. After trying each plate I have settled for the 45 degree rear plate which neatly tucks the cable against the adjoining wall and takes up little space in the corner of the shed.
Basically, decide where you want to fix it, drill a 30mm diameter hole to allow for the nut at the rear of the flange nut, drill the 4 holes for the fixing screws, slide the desired rear plate up to the correct position on the cable, push into place over the screws and then tighten the nuts.
Be sure to treat the 30mm drilled hole with creosote before assembling.

I have included a file for a rain shield to ensure the external fittings stay dry