Thingiverse
16mm Power Switch Button Mount
von Quittik
0
Downloads
0
Likes
0
Makes
Print face down so there is no need for supports.
Just a very basic 16mm power button mount to put magnets, tape etc on to mount a power button. If you need anything just ask. about a 20-30 minute print.
Just a very basic 16mm power button mount to put magnets, tape etc on to mount a power button. If you need anything just ask. about a 20-30 minute print.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
