Thingiverse
Light Plate for Kossel Mini printer - LED Strip lights
by kmccon
45
Downloads
36
Likes
0
Makes
This is a simple light switch for a kossel mini type printer.
What I really wanted to show was that 12 Volt .4 x .1 Waterproof LED strip lights will fit very nicely in 20 series Aluminum extrusions. They put out a lot of light and fit snugly in the channel. I ended up using 2 sets of 9 long LED strips. I soldered wires to the terminals, covered with heat-shrink and wired to the power supply through the switch. You need an open end to slide the strip through.
9 LEDs sit just below the
What I really wanted to show was that 12 Volt .4 x .1 Waterproof LED strip lights will fit very nicely in 20 series Aluminum extrusions. They put out a lot of light and fit snugly in the channel. I ended up using 2 sets of 9 long LED strips. I soldered wires to the terminals, covered with heat-shrink and wired to the power supply through the switch. You need an open end to slide the strip through.
9 LEDs sit just below the
Sign in to leave a comment
Sign in