Thingiverse
Flashforge/Dremel Spool Holder
by Terrapinmfg
120
Downloads
88
Likes
0
Makes
After an initial failed attempt at a new spool holder for the Flash Forge Dreamer and the Dremel Idea Builder I settled on this design.
This design replaces the side vent panels on either machine. On the Dremel you can run the filament through the fan grates in the back of the enclosure.
On the Flash Forge you will need to print the hollow bolt filament guide and drill a 3/8" hole in the lower corner of the printer enclosure.
These work quite well. the spool holder fits Makergeeks.com
This design replaces the side vent panels on either machine. On the Dremel you can run the filament through the fan grates in the back of the enclosure.
On the Flash Forge you will need to print the hollow bolt filament guide and drill a 3/8" hole in the lower corner of the printer enclosure.
These work quite well. the spool holder fits Makergeeks.com
Sign in to leave a comment
Sign in