Thingiverse
ATX PSU mount
by printingSome
8
Downloads
10
Likes
0
Makes
Just a mount for an ATX PSU for my Prusa i3 (Hesine) printer.
But, before you read further, check the "Power and Controller mounting for Makerfarm Prusa i3" by moczys, http://www.thingiverse.com/thing:620172.
I saw it only when I was about to publish this one and I find it much nicer, more elegant.
I would have adapted it to my needs, if I had seen it earlier.
The PSU is a BeQuiet PSU Power 7 300W, but the mount should be ok for some others with the overall measurements of 86 x 150 x 140mm
But, before you read further, check the "Power and Controller mounting for Makerfarm Prusa i3" by moczys, http://www.thingiverse.com/thing:620172.
I saw it only when I was about to publish this one and I find it much nicer, more elegant.
I would have adapted it to my needs, if I had seen it earlier.
The PSU is a BeQuiet PSU Power 7 300W, but the mount should be ok for some others with the overall measurements of 86 x 150 x 140mm
Sign in to leave a comment
Sign in