Thingiverse
Belted Extruder V2. for 1.75mm Bowden
by dintid
98
Downloads
56
Likes
0
Makes
New edition now available: Belted Extruder v.3 for 1.75
----
This is my finished Belted Extruder (V2) for 1.75mm filament.
I have worked hard to make it wotk with flexibles as well. There is less than 1mm room between idler and filament-outlet hole when filament is loaded.
I have not tested it with flexible though, as I do not have any 1.75 flexibles on hand.
You do not have to open idler to load filament, which makes it very easy to change filament!
This is replacement remix of my p
----
This is my finished Belted Extruder (V2) for 1.75mm filament.
I have worked hard to make it wotk with flexibles as well. There is less than 1mm room between idler and filament-outlet hole when filament is loaded.
I have not tested it with flexible though, as I do not have any 1.75 flexibles on hand.
You do not have to open idler to load filament, which makes it very easy to change filament!
This is replacement remix of my p
Sign in to leave a comment
Sign in