Thingiverse
Spring Clamp for 5mm Rod
by abasir
10
Downloads
1
Likes
0
Makes
I used this to hold the torsion spring in place for my micromake delta printer.
These clamps are VERY TIGHT, to prevent them from sliding along the rod.
I placed them in hot water before putting them on the rod so that it soften up a bit and the water also acts as temporary lubricant.
You need to print 12 pieces.
The springs I used are from here
http://www.aliexpress.com/item/10pcs-3D-printers-DIY-Reprap-Kossel-delta-Rostock-strong-spring-pushrod-springs-tension-spring-damping-36/323717
These clamps are VERY TIGHT, to prevent them from sliding along the rod.
I placed them in hot water before putting them on the rod so that it soften up a bit and the water also acts as temporary lubricant.
You need to print 12 pieces.
The springs I used are from here
http://www.aliexpress.com/item/10pcs-3D-printers-DIY-Reprap-Kossel-delta-Rostock-strong-spring-pushrod-springs-tension-spring-damping-36/323717
Sign in to leave a comment
Sign in