Thingiverse
IWB Holster for Kel-Tec P3AT and Ruger LCP
by Reacher01
78
Downloads
56
Likes
0
Makes
This is my original idea for an IWB holster for our pocket .380s. But this could work for any single stack 9mm or .380.
Made for a P3AT, compatible with an LCP. This concept can be extended to almost any other gun.
Print it in PLA, with plenty of support.
After removing support, with your unloaded gun at hand, heat up the plastic until it becomes very malleable. You can use an heat gun or your cookers. Just be careful not to burn your fingers.
When the plastic is hot, place the (unloaded
Made for a P3AT, compatible with an LCP. This concept can be extended to almost any other gun.
Print it in PLA, with plenty of support.
After removing support, with your unloaded gun at hand, heat up the plastic until it becomes very malleable. You can use an heat gun or your cookers. Just be careful not to burn your fingers.
When the plastic is hot, place the (unloaded
Sign in to leave a comment
Sign in