Quadruple Oblong for 144 MHz

Parts for DK7ZB design of Quadruple Oblong for 144 MHz
====================

http://www.qsl.net/dk7zb/Quadlong/4xoblong-2m.htm

Print from any material, without support.

You need one top holder, one dipole holder and 3 same holders.

The dipole is designed for BNC connectos.

Elements are made from 4x1 brass tube and 1.5 mm copper wire.

As support is used fibre glass pole from DX Wire, you can use any non metalic support.

SWR is good in whole 2m band.

If you have no 3D prin