Foot ends for 4040 V Slot Extrusion - Cable Management Hax

I am a bit OCD and wanted to hide my endstop and extruder wiring in the center channel of my 4040 v slot on my Big Delta. I designed these feet to attach to the bottom of my 4040 verticals to do accomblish the following:

--Raise the printer off the ground a bit to allow more vertical height to install psu/electronics/wiring.
--Allow access to the center channel to run wiring from the electronics at the bottom of my printer, to the end stops and extruder compoenents at the top of the printer