Thingiverse
'97-'06 Jeep TJ Automatic Shift Indicator Lower Bracket
by dusin1
69
Downloads
32
Likes
0
Makes
This is a replacement for the bottom of the Indicator Assembly on a TJ Jeep Wrangler with an automatic.
The finished part should measure 5.100" L x 3.615" W and 1.818" Tall
The holes that are molded in the top cover bosses are too large for the #6 screws as molded. Fill these bosses with epoxy, let cure & drill them out with a 1/8" bit. After which you can mount this printed bottom to the top bezel with #6 x 1/2" thread forming screws.
Note: if your bottom posts broke off inside the b
The finished part should measure 5.100" L x 3.615" W and 1.818" Tall
The holes that are molded in the top cover bosses are too large for the #6 screws as molded. Fill these bosses with epoxy, let cure & drill them out with a 1/8" bit. After which you can mount this printed bottom to the top bezel with #6 x 1/2" thread forming screws.
Note: if your bottom posts broke off inside the b
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in