Malyan M150 Z Brace

Z brace for the M150.
You'll need:
2 13-5/8" long 11/32" rod
14 M3x8 screws
14 M3 flat washers.

I printed this at 100% infill, .2mm layer height, no supports. Some support would clean up the overhang a bit.

Included is the .123dx file so you can adapt this brace to other rod sizes.

To assemble:
Chuck the rod or tube into a drill, and spin it into the top brace til it is a bit over an inch deep for the top and an inch and a quarter for the bottom. The friction will soften the inne