Thingiverse
FPV Camera Holder
by feiticeir0
4
Downloads
3
Likes
0
Makes
This a FPV Camera Holder replacement for the RealACC 210mm frame. I tried to make it close as possible to the original. Mine broke in two after a crash and I had to create a replacement.
It is 1.5mm thick . You probably need to file the frame holes a bit for this to fit. The only way to fit the support was to make it 1mm thick, but it is way too bendable and breakable.
Probably it will fit in other 210mm frames
It is 1.5mm thick . You probably need to file the frame holes a bit for this to fit. The only way to fit the support was to make it 1mm thick, but it is way too bendable and breakable.
Probably it will fit in other 210mm frames
Sign in to leave a comment
Sign in